Solution for Bent Tube Leg of Husky Brute Electric Trailer Jack
Question:
I bent the main shaft that comes out of the tube. Is there a replacement shaft or do I need to buy a whole new unit?
asked by: Anita
0
Expert Reply:
If you bent the main shaft of the Husky Brute Electric Trailer Jack # HT87247 you'd have to replace the entire jack as just the inner or outer tube of this jack is not available. Since the Brute is no longer available, I recommend the Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 5,000 lbs - Black
Item # JET-5000 as a replacement.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 5,000 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Leveling Jacks
- Tongue Jack
- Steel
- 4001 - 5000 lbs
- Electric Jack
- 23 Inch Lift
- Bolt-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: Trailer Wiring Diagrams
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Components for Off-Road Trailer Similar to Chevy Colorado Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Add Tension to Solera Slide-Topper
- Q&A: Slide Topper Recommendation for Box Width of 90.5 Inches on Gulf Stream Vintage 23BHS
- Article: How to Choose the Right Trailer Hitch Class
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them