Installing Pop & Lock Custom Tailgate Handle # PAL8540 on 2013 Toyota Tacoma
Question:
I am Currently intalling this kit on a 2013 Toyota Tacoma access cab and the instructions state that a blue with light red wire and blue with black wire run up to the door and those are the lock and unlock wires however i can Not find any blue with black wire running to the door any information is helpful.
asked by: Mark L
Expert Reply:
The two blue wires (one with red stripe and one with black stripe) will be found just inside the driver side door under the bottom plastic panel. The panel will need to be pulled up and the needed factory wires will be inside a black loom. I have attached an installation video on the 2015 Tacoma that you can use for reference. The process should be identical on your truck.
Please let me know if you still cannot locate the correct wires and I will be happy to look into this further.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock with Handle - Power Lock and Manual BOLT Lock - Black
- Tailgate Locks
- Tailgate Handle
- Power and Manual Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How To Confirm Fit of Rear View Safety Backup Camera for Pickup Trucks
- Article: Performance Chips and Modules
- Article: Roof Rack Information
- Article: Rooftop Cargo Carriers
- Q&A: Where Are The Wires For Pop & Lock # PL8540 Located In A Two Door 2015 Toyota Tacoma
- Q&A: Difference Between PAL8540 and PAL8550 For a 2007 Toyota Tacoma
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Q&A: Camera Mounting Clip for Pop & Lock PAL5400 Custom Tailgate Handle with Lock
- Q&A: Tailgate Handle with Backup Camera for a 2015 Toyota Tacoma
- Q&A: Locking Tailgate Handle Recommendation for a 2014 Toyota Tacoma with Back Up Camera