Dimension of etrailer A-Frame Jack From Bracket to Bottom of Tube
Question:
Could you tell me the measurement from the bottom of the flange to the bottom of the tube?
asked by: Frank A
0
Expert Reply:
When the etrailer Round, A-Frame Jack # TJA-5000S-B is retracted the measurement from the mounting bracket to the bottom of the tube is 8-3/8".
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- 16 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Jacks
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Mounting Tab and Hole Size and Spacing of Ultra-Fab # UF48-979006 Scissor Jack
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing
- Q&A: Which is Better, a Side Wind Trailer Jack or a Top Wind Trailer Jack
- Q&A: How Wide Is the Head on the Bulldog Powered Drive Trailer Jack
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Availability of 5,000 lb Top Wind Trailer Jack with Grease Zerk Fitting