How Would a Custer Back-Up Alarm Install on a Reverse Light Circuit of a Vehicle with a 7-Way
Question:
Where can I get the installation instructions for BKUP-97? I see 2 contacts for the unit. is one is for goiund? and can I hook the other to the purpule wire from my 7 pin trailer harness? Thanks
asked by: Paul
Expert Reply:
What you could do to install this Surface Mount Back-up Alarm # BK97DB is install it inline with the purple wire of your 7-way. You would cut the purple wire and then attach one end of the wire to one of the contact studs and then attach the other wire to the other stud, and then when there is voltage on this circuit the voltage will run through the # BK97DB activating the alarm and then go to the 7-way.
I attached an FAQ article on trailer wiring for you to check out also.
Product Page this Question was Asked From
Surface Mount Back-up Alarm - 97 DB
- Back Up Alarm
- Low Volume
- 97 Decibels
- Surface Mount
- Custer
more information >
Continue Researching
- Q&A: Backup Alarm to Fit a 2013 Honda Pilot
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Article: Rooftop Cargo Carriers
- Article: Trailer Maintenance Schedule
- Q&A: Backup Alert for a 2010 Freightliner Sprinter 2500
- Q&A: Is there a Backup-Alert Reverse Light for Bulb Type 921 for the 2013 Chevrolet Equinox
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Does 300 Amp Hour Battery Have Power for Furrion Chill HE RV AC Unit
- Q&A: Will Switching from a 13,500 BTU RV AC to a 15,000 BTU RV AC Be Quieter
- Q&A: Backup Alert for a 2006 Chevy Silverado 2500
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)