My Follow Leg Has Different Gearing Than the Lead Leg
Question:
The follow leg on my 1998 Nash 29.5 Fifth wheel gave out. I replaced it with this leg. The length was pretty close, but I did have to weld on a piece of steel as the side stops were not the same. But it works great other than it is geared significantly lower than the lead leg. Consequently, the new follow leg moves much, much slower and they end up vastly uneven. In fact, when taking the trailer off the truck, I tried to compensate for it, but I had to have the entire weight on the lead leg. My question is are they any options for just replacing the gears in the top of either of the legs to make them match? I have no idea what brand the original legs are as when I had them off, there were no markings. But from what I could guess from research is they might have been Atwood. I threw out the old leg so I do not know the number of teeth in those gears and I would have to totally dissemble the lead leg again to get to the gears. Any and all help is greatly appreciated!
asked by: Tom
Expert Reply:
I have an option to get the legs on your 1998 Nash 29.5 Fifth wheel to even out, but unfortunately gears are brand specific, so you won't be able to install replacement gears that will even out the gear ratio between two different brand legs.
The most efficient option is to replace the lead leg with the matching Replacement Lead Leg for Stromberg Carlson Landing Gear # LG-177202. Replacing the leg will enable you to keep the legs moving at the same speed and will even out your trailer.
Products Referenced in This Question
Replacement Follow Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Stromberg Carlson
more information >
Replacement Lead Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Replacement Follow Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Correct Replacement for Kwikee Step Motor 369545
- Q&A: Replacement Follower Leg for a Venture VMC900L Landing Gear Set
- Q&A: Lippert Components Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear Install Diagram
- Q&A: Replacing ADTH 1RV-200 Landing Gear Motor
- Q&A: Replacement Landing Gear for VMC900R
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Lead and Follow Landing Gear Legs to Replace 71488 on 2012 Jayco
- Q&A: 5th Wheel Landing Gear Clicks and Won't Go Up or Down
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: Where to Position the Trailer Axle?
- Article: My Trailer Hitch Doesn't Fit
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: Best Camper Jacks