Can the Timbren Silent Ride Suspension Install on an I-Beam Trailer Frame
Question:
I HAVE an interstate I beam to mount a Timbren is this workable?
asked by: Richard
0
Expert Reply:
Yes, the Timbren Silent Ride Suspension part # TSR2000S03 will work with an i-beam trailer frame but you will need to weld a plate to the side of the trailer to provide a flat mounting surface for the Silent Ride. This has been done many times before without issue but there will be an extra step that is not usually required for your i-beam.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Timbren Silent Ride Suspension for Single Axle Trailers w/ 2-3/8" Round Axles - 2,000 lbs
- Trailer Leaf Spring Suspension
- Leaf Spring Replacement System
- Camper
- Car Hauler
- Utility Trailer
- 2000 lbs
- Round Axle - 2-3/8 Inch
- Single Axle
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Q&A: Recommended 5 Lug Timbren Axle-Less System for 13" Trailer Tires
- Article: Trailer Tire Sizing
- Q&A: Do the Timbren Silent Ride Suspension Systems Require a Crossmember
- Q&A: 2024 Chevy Equinox Roof Rack Recommendation for a Bare Roof
- Q&A: How To Determine If Timbren Trailer Suspension Enhancement # TTRA1702 Will Fit Single Axle Trailer
- Q&A: Could Demco Actuator part # DM72VR be Manually Locked Out with Rod
- Article: Trailer Wiring Diagrams
- Q&A: Replacement 12" Dexter Axle Hydraulic Drum Brake Kit with Parking Brake Lever
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height