Rebuilding etrailer.com Square Direct Weld Jack # TJD-7000S
Question:
I CAN NOT FIND A BREAK DOWN OF PARTS OR A SCHEMATIC OF THE 7000# JACK.I TOOK IT APART TO FIX, AND CANT REMEMBER WHERE THE WASHER GOES.I SHOULD HAVE TAKEN A PICTURE. DID NOT I WOULD BE SO LONG FOR PARTS.O WELL. THANKS
asked by: SAMUEL I
Helpful Expert Reply:
While we don't have a complete parts diagram for your Square Direct Weld Jack # TJD-7000S available, we do have a thorough installation video for rebuilding the jack that you can use for reference. I have attached the video to this answer page. This will show you exactly where all the inner components install, including the washer that you mentioned.
Product Page this Question was Asked From
Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Fifth Wheel Trailer
- Gooseneck Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 6001 - 7000 lbs
- Sidewind Jack
- 28-7/8 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Do You Cut Tabs on Both Stacked SeeLevel Sensors SE88VR
- Article: Trailer Wiring Diagrams
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Voltage Used by the SeeLevel Sensors # SE27VR
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Diagnosing Overload Warning, No Brakes, On a Tekonsha Prodigy P3 Brake Controller
- Q&A: Is There a Replacement Drop Leg for the Bulldog Square Jack - 3,000 Lbs 195354
- Q&A: Is 14 Gauge Wire Too Small for Electric Trailer Brakes
- Q&A: Free-Backing Drum Brakes for M101A2 Military Dump Trailer
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: How Far Forward Should Motorcycle Wheel Chocks Be Installed in a Utility Trailer
- Article: Trailer Jacks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule