Troubleshooting Lights not Working
Question:
My truck lights work great , have no power to only drivers side , yellow wire to quick disconnect has no power , for blinker ,stop, must be on same line. Fuses all good, has to be in plug or line someplace, but where do l start?
asked by: Fred E
Expert Reply:
I'll give you the comprehensive list of troubleshooting so you can cover all your bases and get your lights working again. In many cases a bad ground is to blame for this type of issue, but in order to determine the specific problem you'll need to use a circuit tester such as # PTW2993 to test the connector on your truck after disconnecting it from your trailer. Check the wiring going into your harness from your taillights to see if those wires are carrying the correct signals, if not then the issue is with the vehicle wiring. If the signals going to your harness are okay, you'll need to test the signals coming out of the harness, and if they are correct then your issue is likely going to be with the trailer side wiring.
As I mentioned above, an important issue you will want to take a look at are the ground connections, as they can be the cause of numerous lighting problems. You'll want to make sure your grounds are securely attached to bare metal surfaces free of any paint, dirt or corrosion of any kind. Also check your wiring thoroughly to ensure there are none that are crimped, broken or otherwise damaged. I've added links to a pair of help articles on trailer wiring that you may also find useful.
Products Referenced in This Question
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Q&A: Replacement for Pollak PA66-MD40 Connector
- Q&A: Recommended Flat Towing Setup for a 2016 Jeep Wrangler Using a ReadyBrute Elite II Tow Bar
- Article: Flat Towing Package for 2011 Chevrolet HHR
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Q&A: Blule Ox Baseplate For A Diesel 2020 GMC Sierra 3500 Denali
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: How To Mount Pollak Connector PA66GF30