Troubleshooting Slide Out Motor that Moves a Few Inches then Stops for 30 Seconds
Question:
My slides would go in about 6 inches then stop. Wait 15-30 seconds then would go in another 6. Now it stopped completely. Is it the solenoid or the motor. Dont have access to multimeter.
asked by: Randy R
0
Expert Reply:
That sounds like a bad motor to me. Sounds like the motor has weak coils and when gets warm or hot from use they aren't able to carry enough amperage to operate.
You'll have to check out your setup to see which slide out motor you'd need. I attached a link to a page that has all of the ones we carry.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units
- RV Slide Out Parts
- Motor Parts
- Solenoid
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Troubleshooting a Lippert Level-Best Leveling System that Suddenly Stopped Working
- Q&A: How to Clear the LR Jack Code on a Lippert Ground Control 3.0 Stabilizer Jack
- Q&A: Troubleshooting Slide-Out Function Where Solenoid Clicks But Doesnt Move Motor
- Q&A: Does Wire Run to Top Terminal of Trombetta Solenoid Switch
- Q&A: How to Replace a Hydac Cartridge Valve on a RV Slide-Out Hydraulic Pump
- Q&A: Troubleshooting Auto Level Fail Error on Lippert Ground Control System
- Q&A: Determining if Spacers Are Needed to Install Reese Goose Box on Trailer Frame
- Article: Trailer Wiring Diagrams
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Rooftop Cargo Carriers
- Article: How to Bleed Your Trailer Surge Brakes
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 2023 Best Gifts for RVers & Campers
- Article: Best RV Roof Vents