What is the Height of the Chocks That Come with the PackEm Wheel Tie-Down Kit # PK-WTD
Question:
NOT sure if my rear engine riding mower would drive OVER these, what is the measurement from the base where they bolt to a surface TO the top highest point? This will help me determine if MY mower can pull over them.
asked by: Numa
0
Expert Reply:
If you want to mockup a trial run to see if your lawn mower can get over the Pack'Em Wheel Tie-Down Kit # PK-WTD then you need something that is 7" wide x 5-5/8" long x 1-5/8" tall. The height of 1-5/8" is from the mounting surface to the highest point of the chock so your test item would need to be at least that high.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Pack'Em Wheel Tie-Down Kit for Truck Beds and Trailers - 30" Tires - 800 lbs
- Car Tie Down Straps
- 6 - 10 Feet Long
- Wheel Net
- 501 - 850 lbs
- PackEm
more information >
Continue Researching
- Q&A: Recommended Tie Down Strap for a 2010 Jeep Wrangler With 35" Tires
- Article: Rooftop Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Trailer Jack for Shelby Model 5764A on Boat Trailer
- Q&A: Recommended Tie-Down Kit for Golf Cart Transported in Pickup
- Article: Trailer Wiring Diagrams
- Q&A: Will the Replacement Velcro Strip for Extang Express Tonneau Covers Fit a Ionic Tonneau Cover?
- Q&A: Can E-Track be Driven Over and be Used to Secure Vehicle Tire To
- Q&A: Recommended Way to Secure Vehicle to Trailer that Is Towed Behind Motorhome
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Recommended Wheel & Tire Tie Down Straps For Tesla Model Y with 255/40R20 Tires
- Article: How to Install E-Track in 3 Easy Steps
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Best Tire Chains