Leveling Jack for Motorhome
Question:
Have a 08 Tiffin Phateon with the atwood system. The front levellers keep breaking shear pins. In the past was able to obtain new pins directly from Atwood. The last attempt to obtain some more shear pins, was advised they did not have any, and to remedy my problem, a new leveller would have to be obtained. Can you advise on this, as I have been putting in pins that dont seem to last at all. Thanks so much
asked by: Cam D
Expert Reply:
To add a new leveling jack to your 2008 Tiffin Phaeton I recommend checking out the Ultra-Fab Power Twin II Electric Stabilizer # UF39-941707 which will work on the rear of your Phaeton so long as it has a frame that is between 42" and 77"; it also require 24" of space on the frame of your motorhome. This has a pair of 12V motors that level independently of each other and has a 6,000 lb weight capacity.
For a manual option there is the Ultra-Fab Ultra Scissor Jacks # UF48-979002, which has a 13,000 lb support capacity and will either bolt or weld onto your '08 Phaeton.
Products Referenced in This Question
Ultra-Fab Power Twin II Electric Stabilizer for Trailers and RVs - 22" Lift - 6,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Travel Trailer
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
more information >
Ultra-Fab Ultra Scissor Jacks - 24" Lift - 13,000 lbs - Qty 2
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Scissor Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Replacing Electric Landing Gear on 5th Wheel Trailer with Auto-Leveling System
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Which Snappads for 2025 Entegra Aspire
- Q&A: Install Manual for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System
- Q&A: Shorter Replacement Rear Jacks For Lippert Ground Control 3.0 4-Point Leveling Increased Clearance
- Article: How to Raise Your Travel Trailer Height
- Q&A: Will The Lippert Ground Control Fit My 2020 Genesis Supreme 5th Wheel Toy Hauler?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Gooseneck to 5th Wheel Adapters
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Best RV Roof Vents