Troubleshooting Running Lights on Trailer
Question:
all the lights work on my trailer except the tail lights and marker lights.
asked by: Chuck T
Expert Reply:
The first step to troubleshoot your problem would be to determine if the wiring problem exists on the vehicle or on the trailer. Turn on the vehicle headlights and use a circuit tester like part # PTW2993 on the pin on the trailer connector that feeds the running light circuit. If your vehicle has a 4-pole connector, test the pin being fed by the brown wire. If you are dealing with a 7-way connector, you would test the pin in the 11:00 position.
If the tester indicates voltage on the pin you are testing, the problem is with the trailer wiring. Start with the connector on the trailer. Make sure it is not damaged or corroded. 4-pole connectors are known for having the wire insulation crack right behind the connector after a few years. Once the insulation cracks, moisture can cause the copper conductor to corrode, and current will not pass through.
Trace the running lamp circuit back from the connector (usually a brown wire) Since none of your running lights are functioning, chances are that the problem will be between the trailer connector and the first marker light. Look for cracked or worn insulation. Make sure all connections at each marker light are tight, and that each lamp is bolted directly to clean metal. If each lamp has a separate ground lead, make sure those are securely connected to metal on the trailer frame.
If you are not getting a signal on the running lamp pin, how to proceed will depend on the year, make and model of the vehicle, as well as the type of trailer connector on the vehicle and if the vehicle is equipped with the factory tow package.
If you would respond with that information, I can provide more specifics. I've linked you to some trailer wiring FAQ articles that I hope you'll find helpful.
Products Referenced in This Question
Product Page this Question was Asked From
4-Way Flat Trailer Connector w/ 60" Harness and Wire Taps
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Tekonsha
more information >
Continue Researching
- Q&A: Can Hitch Ball Size Be Changed Out on Curt Euro Style Ball Mount
- Q&A: Installing a 4-Pole Trailer Connector at Rear of 5th Wheel for Towing Boat Trailer
- Q&A: How to Add 4-Way to the Back of Camper Trailer for Towing Second Vehicle
- Q&A: How to Wire a Stop/Turn/Tail Trailer Light With Two Wires to a Trailer
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Article: Flat Towing Package for 2002-2004 Jeep Liberty
- Q&A: Installing 4-Pole Trailer Connector on 2002 Chevy Silverado with No Trailer Connector
- Q&A: Installing Trailer Wiring Harness on 2009 Lexus RX350 with Factory Tow Package
- Q&A: Are Rubber Wheel Chocks Better Than Plastic for Trailers
- Article: How to Measure for Trailer Hitch Drop