Recommended JT's Strong Arm Jack Stabilizer Kit for 2014 Wildcat 5th Wheel Trailer

Question:

I want to install JT Armstrong’s on my 2014 Wildcat 317RL on the front and rear. The distance between front landing arms is 60 inches. I have electric stabilizers on the rear and will need whatever parts are necessary so stabilizers will completely retract. I would like to install ASAP. Thank You

asked by: Jerry A

Expert Reply:

Since you measured a distance of 60 inches between the landing gear on your 2014 Wildcat 5th Wheel Trailer, the correct JT's Strong Arm Jack Stabilizer Kit is part # LC191023. One end of each stabilizer tube will attach to each landing gear leg and the other will attach to the trailer's frame. The kit includes 6 stabilizer tubes - 4 for the front of the trailer and 2 for the rear.

If you have Lippert electric stabilizer jacks, then you will just need to use the Adapter Set # LC314597. This will allow the stabilizers to fully retract when using the JT Strong Arm Kit.

expert reply by: Chris R

Karen J.

6/3/2020

We have a Jayco Seismic 4113 with hydraulic stabilizers. Can you install a JT strongarm kit on a hydraulic stabilizer? The Rv moves a lot and we had the JT on our last fifth wheel and it did wonders.

Chris R.

6/8/2020

You sure can! To add the JT's Strong Arm Kit # LC191023 to your Jayco Seismic equipped with the hydraulic jack system you'll just need to add the Hydraulic Jack Adapter Lugs # LC314592.