Distance Between Mounting Holes of CIPA Adjustable Mirror # CM01139
Question:
Our JD 835R Gator has a enclosed cab with plug and play holes to bolt on side mirrors. What is the distance between the bolt holes on your #CM01139? Thanks.
asked by: Phyllis
0
Expert Reply:
The distance between the mounting holes of the CIPA Adjustable Mirror part # CM01139 is 2-3/16 inches. That dimension is measured on center.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CIPA Adjustable Side Mirrors for UTVs - 7-11/16" x 4-5/8" - Round Clamp - 1 Pair
- ATV-UTV Mirrors
- UTV Mirror
- Roll Cage
- Clamp-On
- Left and Right Hand
- CIPA
more information >
Continue Researching
- Q&A: How to Tell if 2023 Lexus RX 350 Exhaust Needs to Be Lowered to Install Curt Trailer Hitch
- Q&A: Replacement Motor Solution for Kwikee Series 32 RV Step Made in 1996
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: CIPA CM01139 Adustable Side Mirrors for Kubota 1120D UTV
- Q&A: Does Timbren Make a 10,000Lb Axle Less Trailer Kit?
- Article: Trailer Tire Sizing
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Q&A: Proper Trailer Bunk Board Length for 21 Foot Boat
- Q&A: How do the Magnets of Dexter 7 inch Brake Assemblies Attach
- Q&A: Dexter Trailer Brake Magnet for 7 inch Brakes
- Article: Printable Trailer Bolt Hole Pattern Template
Jessica
4/5/2020
Would these fit a 2020 can am defender