Tool Used to Tighten Spindle Nut on Trailer Hub
Question:
So if the spindle nut is 1inch what is the size of the socket to install this nut?
asked by: Kent
0
Expert Reply:
Spindle nuts do not get torqued down hard so normally people will use a set of channel locks or a large crescent wrench when installing spindle nuts when installing the part # 31-71-3.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
50MM Nev-R-Lube Bearing for 8,000-lb Dexters - Qty 1
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 50 MM I.D.
- Bearing 31-71-3
- 8000 lbs Axle
- Dexter
more information >
Continue Researching
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: Procedure for Replacing 31-71-3 50mm Sealed Nev-R-Lube Bearings
- Q&A: Do Nev-R-Lube Bearings Last a Long Time
- Q&A: Is There 5,200 lb Trailer Hub that has 8 Lug Bolt Pattern
- Q&A: Do You Grease Inside Of Dexter Nev-R-Lube Hub Or On The Spindle Before Installing The Hub?
- Q&A: Locating Replacement Dexter P-15 Axle on Trailer
- Q&A: When to Replace Dexter Nev-R-Lube Bearings
- Article: Trailer Wiring Diagrams
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers