Switching Off Brakes when Traveling Steep Pass?
Question:
Isolate my surge brake solenoid. I would like to wire in a switch to disconnect the surge brake solenoid in order to travel down a steep pass and not burning out my trailer brakes
asked by: Jerry L
Expert Reply:
A solenoid in a surge brake actuator only prevents your brakes from locking up while going in reverse, so disconnecting it would not be effective. Also, please do not go down a steep pass with a trailer and try to avoid using brakes; the weight of the trailer will push your tow vehicle and you won't have as much control. If you go slowly you won't burn out your brakes and more importantly it is much safer to use your brakes when going downhill.
Product Page this Question was Asked From
Hopkins Engager Push-To-Test Trailer Breakaway Kit w/ Built-In Charger - Side Load - 7" Wire
- Trailer Breakaway Kit
- Kit with Charger
- Side Load
- Single-axle
- Tandem-axle
- LED Tester
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Fit of Turnoverball Underbed Gooseneck Trailer Hitch # BWGNRK1313 with my 2006 Dodge 3500 8 Foot Bed
- Q&A: Will Firestone Air Bags Interfere if I Install a B&W Gooseneck Trailer Hitch for a 2004 Dodge 2500
- Q&A: Weight Capacity of Dexter P-12 Model SLR Axle
- Q&A: Installation Instructions For Hopkins Engager Trailer BreakAway Kit
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: How to Run an Electric Jack Off of a Trailer Battery and a 7-Way Connector
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Comparing Trailer Breakaway Switch Kits
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Testing The Dexter Electric Over Hydraulic Brake Actuator