Bolt Pattern on Folding Ball Gooseneck Hitch # C-52
Question:
What is the measurements of the bolt pattern.
asked by: Bob H
1
Helpful Expert Reply:
On the mounting plate of the Curt gooseneck # C-52 the bolt hole centers are 5 inches apart left to right and then 9-3/4 inches across.
expert reply by:
Jameson C
1
click to enlarge
Product Page this Question was Asked From
Center Section for Curt Folding Gooseneck Trailer Hitch
- Accessories and Parts
- Gooseneck Hitch
- Hitch Only
- 30000 lbs GTW
- Fold Down Ball Gooseneck
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Q&A: Scissor Jack Recommendation to Replaced Damaged Ones on R Pod Trailer
- Article: Best Ladder Racks
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Replacement Parts for Fan-Tastic Vent 8000 Series
- Q&A: Parts Needed to Tow a Trailer with a 2015 Honda Pilot
- Q&A: Installation of Hitch on Fifth Wheel Trailer
- Q&A: When Flat Towing a Vehicle How Much Tongue Weight is on the Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Air Bag Suspension (2023)
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch