AC Vent Register Needed for Master Bath in Newmar Ventana LE 4037
Question:
The AC register 7 in our master bath allows directional change but does not allow adjustments to the flow so its freezing upon leaving the shower! I have ordered several replacements but they are all just off when it comes to Hole alignment for the screws maybe 1/8 inch smaller Can you assist?
asked by: Andrew M
Helpful Expert Reply:
I checked out the included screws with the Valterra Heating and A/C Vent Register # A10-3350VP and found them to have a diameter of 1/8" and they were 3/4" long. The mounting holes are separated on center by 3-1/8". You can use all of this info to determine if it will fit your application or not.
A review video of this vent is linked for you to reference as well.
Product Page this Question was Asked From
Valterra RV Ceiling Vent w/ Adjustable Levers and Covered Screws- 4" Diameter - White
- RV Vents and Fans
- Vent
- Ceiling Vent
- Wall Vent
- No Fan
- 5-1/4 Inch Diameter
- Plastic
- White
- Valterra
more information >
Continue Researching
- Article: Overview of Lubricating Grease
- Q&A: Diameter of Hole Necessary for Valterra # A10-3358VP
- Q&A: Gearbox Recommendation for Kwikee Step on 2006 Winnebago View
- Q&A: Recommended Replacement For An Innoflame RV26D80I-1 Rv Fireplace
- Q&A: Recommended Grease Gun and Grease for Tandem Axle Enclosed Trailer
- Q&A: Who Makes the Bearings for AxleTek/etrailer Trailer Hub and Drum Assemblies
- Q&A: Can Regular and Marine Grease be Used in the Same Hub
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Q&A: Replacement Kwikee Step Switch with Normally Closed Circuit
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Article: Big Truck Big RV
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Raise Your Travel Trailer Height