Replacement Breakaway Switch for Trailer
Question:
I drove about 10 miles with the break away switch cable disconnected. What damage could I have done? The Switch cables got very hot and melted a little......probably need to replace switch Trailer brakes were smoking and smelled bad......need to replace?
asked by: Ron
Expert Reply:
There is some wear and tear from driving with your breakaway kit engaged, but it is likely that the switch is all that will need to be replaced. The brake shoes were working hard and most likely wore down faster than they normally would, and I recommend pulling a hub to do a visual inspection to ensure there is still enough brake pad left. As long as there is some brake material left and it doesn't have a smooth glade on the outside of the pad, you don't need to replace them. If there is, let me know if you have 10 inch or 12 inch brake assemblies.
If the visual inspection is good, then you can simply replace your breakaway switch with the Replacement Breakaway Switch for Trailer Breakaway Kits # 3802348 or the Hopkins Replacement Break-Away Switch, 44" Lead Wires # HM20014. Your breakaway trailer battery may need to be charged so you can check that as well.
Products Referenced in This Question
Hopkins Replacement Break-Away Switch, 44" Lead Wires
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Hopkins
more information >
Product Page this Question was Asked From
Replacement Breakaway Switch for Bright Way Trailer Breakaway Kits
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Bright Way
more information >
Continue Researching
- Shop: Replacement Breakaway Switch for Bright Way Trailer Breakaway Kits
- Q&A: Replacement Pin for ESCO Trailer Breakaway Kit
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Direct Connect Base Plate Kit for a 2021 Jeep Wrangler and a Falcon All Terrain Tow Bar
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Cable and Pin for Bright Way Breakaway Switch on Trailer 2348
- Article: How to Measure a Trailer Axle
- Q&A: Installing Electric Brake Controller on 2014 Chevrolet Express Van Without Factory Tow Package
- Q&A: Where is the Brake Switch Wire on a 2014 GMC Savana Van to Install a Brake Controller
- Q&A: Can You Install an EZ Lube Hub and Drum on a Non EZ Lube Axle
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Complete Flat Towing Setup for a 2021 Chevrolet Blazer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Finding the Right Electric Winch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)