Diagram for Wiring In Atwood Switch part # AT91959

Question:

I bought and received this switch to switch the water heater on and off from 110 volt circuit. In order to use this switch which pins do I connect to power the red light and the water heater. I know where the pin is for the ground in your diagram. Where does either side of the hot wire go, 2 pins. I will not use the 12 Volt pin.

asked by: Bill K

Expert Reply:

The only way I can recommend you wire up the Atwood Switch part # AT91959 is by using the attached diagram which means using a 12 volt power source. I don't have a way we can recommend using a 110.

expert reply by: Jameson C