How to Install the Grease Seal Part # 168233
Question:
WHICH WAY DOES THE RUBBER LIP FACE, TOWARD BEARING OR TRAILER ???? PICTURE IN VIDEO NOT GOOD. ??
asked by: Ralph
0
Expert Reply:
The rubber lip on the Grease Seal part # 168233 will face towards the trailer which means the open end will face towards the bearing. The installation process can be seen in the attached review video. In order to remove the old seal you will want to use the Seal Puller part # PTW1219. I have attached a video that shows how the puller is used as well.
expert reply by:
Conner L
0
Products Referenced in This Question
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.688 Inch I.D.
- 2.332 Inch O.D.
- Redline
more information >
Continue Researching
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: Trailer Maintenance Schedule
- Q&A: How Can I Remove RV Roof Coating From The Side Of My RV?
- Q&A: Does Primer Need to Be Applied to Aluminum Roof Before Applying Alpha Systems 4034 Roof Coating
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: How To Install HBA-CAM Hydrastar Adapter
- Q&A: LCI Leveling System Troubleshooting
- Article: Trailer Tire Sizing
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Most Popular Wheel Bearings
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How Much Does a Boat and Trailer Weigh?