Can Only Some Trailer Lights be Changed to LED or do All the Lights have to be Changed
Question:
Any reason these LED lights cant be used to replace two existing incandescent clearance lights without upgrade the rest of the trailer lights to LED?
asked by: Geoffrey C
0
Expert Reply:
You do not have to change all of the trailer lights to LEDs in order to install and use the LED Trailer Fender Clearance Light # MCL180ARB. You can have a mix of LED and incandescent. The only drawback is that if you had an LED light right next to an incandescent light the brightness between the 2 would be different.
expert reply by:
Michael H
0
Product Page this Question was Asked From
LED Trailer Fender Clearance Light - Submersible - 2 Diodes - Amber/Red - Driver or Passenger Side
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 8-1/2L x 1-11/16W Inch
- Red and Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Stability Control for Heavy Duty Vehicles
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Lights Needed for 102" Wide x 25' Long Trailer
- Q&A: Can I Install the Thinline LED Trailer Tail Light Vertically Where It Will Be Submerged?
- Q&A: Reverse Light PIn on a 7-Way Trailer Connector
- Q&A: Can FloTool RhinoRamps Max Vehicle Ramp Set Hold the Weight of a 2021 Ram 3500
- Q&A: Hitch Pin Weight Capacity and Sheer Strength
- Q&A: Reversible Lens on the LED Trailer Fender Clearance Light
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Will The AM31990 Tire/Wheel Fit On The etrailer Hitch Mounted Spare Tire Carrier e98ZR
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller Installation: Starting from Scratch