Replacement Braking Assembly for Offset Four Bolt Brake Mounting Flange
Question:
I need a brake assembly for an older trailer with Hammer Blow 6k lb axels that have the offset 4 bolt flange. The only break assembly I have found that would work with this bolt pattern is the Dexter 23-105-106-09. Two questions: Do you carry any other break assemblies that will work with my flange bolt pattern? Will my hubs work with this bake assembly? The current hubs are 12 inch. The brake pads on the old assembly are 2 inch. Three of the hubs have part number K-H85454. I don’t see a brand name. The other one doesn’t match. It is a Dexter hub with part number 8-201. Bearings on all of the hubs are 25580 and LM67048.
asked by: Darren
Expert Reply:
The Dexter Electric Brake Kit part # 23-105-106-09 is the only braking assemblies we have that will work with the offset four bolt brake mounting flange. The dimensions of these assemblies are 12" diameter x 2" wide therefore yes, will work with your existing drums. Unfortunately, the offset four bolt brake mounting flange is not very common so the list of compatible parts is very limited.
If you would like to replace the hub/drum instead of using you old ones then you will want to use the Dexter Trailer Hub and Drum Assembly part # 8-201-5UC3.
Products Referenced in This Question
Dexter Trailer Hub and Drum Assembly for 5,200-lb Axles - 12" Diameter - 6 on 5-1/2
- Trailer Hubs and Drums
- Hub with Integrated Drum
- Standard
- 25580
- LM67048
- For 5200 lbs Axles
- 1/2 Inch Stud
- 6 on 5-1/2 Inch
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- Dexter
more information >
Product Page this Question was Asked From
Dexter Electric Trailer Brakes - 12" - Left/Right Hand - 6K AL-KO/Hayes Axles
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Manual Adjust
- 12 x 2 Inch Drum
- 6000 lbs Axle
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Availability Of 12" Replacement Brakes For Kelsey Hayes 4-Bolt Pattern With 3-1/2" Center Hole
- Q&A: Recommended Brake Assembly 12x2 with 4 Bolt Mounting Pattern
- Q&A: Replacement Brake Assemblies For Al-KO Or Hayes 4-Bolt Flange
- Article: Trailer Wiring Diagrams
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Most Popular Wheel Bearings
- Q&A: Available 12 x 2-Inch 6K-Rated Electric Trailer Brakes with 4-Bolt Mounting Pattern
- Q&A: Brake Flange Needed to Install 12 Inch Brake Assemblies With 5 Bolt Mounting Holes
- Q&A: Replacement Electric Brake Assemblies for 5,200 lb AL-KO Axle
- Q&A: How to Tell if Lippert 7KTrailer Hub and Drum Assembly Will Fit Kaufman EZ4 Trailer
- Article: Trailer Tire Sizing
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Measuring a Trailer Tire
- Article: How to Measure a Trailer Axle