Replacement 3,500 Lb Axle for a Boat Trailer with EZ Lube Spindles
Question:
I have a raft trailer with a 3500# 2 3/8inch diameter axle. It is not submersible. I need to buy a submersible axle and want a Dexter E-Z Lube. I looked at your website but dont see the size I need. Hub Face to Face is 61.75inch and the Spring Seat center to center is 46. I have lots of room horizontally so the hub length is not critical but the Leaf Spring center to center is. Is it possible to get a 3500# Dexter E-Z Lube axle this size? I have photos if you need to see them. Thanks
asked by: David
Expert Reply:
Most trailer axles have a weep hole if water gets into the shaft but the main concern is getting water in the hubs. This can usually be eliminated by using a double lip grease seal. If you can measure the grease seal or read the part numbers you have now then I would see if we have a replacement for you.
However, we do not have a standard axle in the measurements you provided. We do have the Timbren Axle-Less Trailer Suspension System part # A35RS545 that will work as a replacement. This system has a a 3,500 lb capacity and EZ Lube spindles with hubs that accept wheels with a 5 on 4-1/2" bolt pattern.
I have attached a review video of this system for you as well.
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension w Idler Hubs - Standard Duty - No Drop - 5 on 4-1/2 - 3,500 lbs
- Trailer Axles
- Rubber Spring Suspension
- Easy Lube Spindles
- Idler Hubs
- 3500 lbs
- 5 on 4-1/2 Inch
- Universal Fit
- No Drop or Lift
- Timbren
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: Idler Hubs, Bearings, Seals and Grease For a 2015 V22L ShoreLand'r Boat Trailer
- Q&A: Does Bearing Buddy Seal Kit # BB60002 Fit 3,500 lb Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Q&A: Axle Upgrade for my Harbor Freight 1720 Utility Trailer
- Q&A: Can 3,500 Lb Hub be Used to Replace 2,000 Lb Hub with Same Size Bearings
- Q&A: Proper Spacing Between the Hub Face and Spring Center Locations for 7,000-lb Triple Axles
- Q&A: Replacement Axle-Less Trailer Suspension Square Axle 49.5 Hub Face and 38.5 Spring Center
- Q&A: Does It Matter If the Spring Center and Hub Face Is Different When Replacing A Trailer Axle
- Article: 2023 Holiday Must Haves
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Determining Trailer Tongue Weight