LED Hyperflash Fix by Adding Load Resistor
Question:
Which wires do I splice the resistor into? 2016 Ford F 150 Colors please. Thanks
asked by: Stan S
0
Expert Reply:
Load resistors will have one end connected to each positive power wire on your vehicle or trailer and the other wire on the load resistor will go to ground. Unfortunately I can't give you the wire colors of your truck. If you need to determine what color wire and it isn't obvious by the tail light wiring at the bulbs, then I recommend using a circuit tester like # PTW2993 to isolate the power wire on each function you wish to add the load resistor to.
expert reply by:
Jason S
0
click to enlarge
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Parts Needed to Flat Tow 2023 Jeep Gladiator
- Q&A: Can the Curt Custom Tail Light Wiring Kit Be Used With LED Lights
- Article: Trailer Lighting Requirements