Replacement for Fulton Jack 70SP28F
Question:
I have a Fulton 70SP28F trailer jack that has a broken gear that goes on the crank shaft, I do not see any gears listed for that part #. Do you stock them? or possibly have the full jack for sale?
asked by: Jeb R
Expert Reply:
There is a solution for you, though we do not have any replacement parts or a replacement itself for your Fulton 70SP28F.
I looked up the specs for your jack and found that it was a sidewind jack that had a 4,000 lb lift capacity with a retracted height of 22" and extended height of 51".
There aren't many jacks with similar dimensions, but a replacement that can work for you is the Bulldog Square Jack with Footplate # BD180455, which has a 7,200 lb lift capacity, retracted height of 25-11/16", an extended height (with the drop leg) of 54-3/16" and is a direct-weld design.
Product Page this Question was Asked From
Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 28-1/2" Lift - 7,200 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 7001 - 8000 lbs
- Sidewind Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Recommended 7000lb Leaf Springs To Replace Dexter 072-027-00
- Article: Trailer Wiring Diagrams
- Q&A: How To Charge 12v Batteries Wired in Parallel
- Q&A: Using NOCO 2 Bank Charger With Parallel Batteries in Truck
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Replacement Axle For 84 Inch 3,500 Pound Dexter Axle
- Article: Trailer Hitch Receiver Sizes
- Q&A: Replacement Antennas for Voyager WiSight Wireless Backup System
- Q&A: Replacement Kwikee Electric Steps for a 2005 Jayco Greyhawk 31SS
- Article: Stability Control for Heavy Duty Vehicles
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)