How to Pick Out Replacement Bearings for 2012 Palomino 4127Y
Question:
I want to replace the bearings on my 2012 Palomino 4127Y popup camper. Can you tell me which parts I need? Also, I have never done this before so any guidance would be helpful. Thanks
asked by: Doug
0
Expert Reply:
I really wish there was a way to determine what bearings a trailer needed without actually pulling the wheel off and checking, but there isn't. The only two solution I have for you would be to remove the hubs and get the numbers that are stamped on the bearing or for you to remove the hubs and use a digital or dial caliper to measure where the bearings and seal ride (see pic).
With that info I can help you figure out what you need.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Article: How to Measure a Trailer Axle
- Q&A: How to Determine if Trailer has 84 Spindle to Pick Out Replacement
- Q&A: Replacement Hub Assembly for T.D.E. 11033
- Q&A: Where to Measure on Trailer Spindles to Determine Replacement Hubs
- Q&A: Replacement Hub and Spindle for TDE 11033 Hub
- Q&A: Replacement Disc Brake Kit Recommendation for 3,500 lb Axle with #84 Spindles
- Q&A: RV Tire Pressure Monitor with Quicker Refresh Rate