Temporarily Disconnecting Edge Juice With Attitude CS2
Question:
I purchased the Edge Juice with Attitude CS2 for my 2016 Ram 2500. I need to take my truck to the dealer for some work due to a recalled part. How do I unhook the CS2 prior to taking the truck in for service? Is it as simple as unhooking from the OBD-II port and then removing the two cylinder harnesses and reinstalling the original two cylinder harnesses?
asked by: Jason
Expert Reply:
I reached to my contact at Edge and we confirmed when removing the Edge Juice with Attitude CS2 # EP31407, you need to remove the monitor from dash using the OBD-II cable. Also remove the under the hood module and jab wire. When reconnecting plug in all removed wires and restore # EP31407 to stock settings.
Product Page this Question was Asked From
Edge Juice with Attitude CS2 Performance Tuner - Color Screen - Dodge
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Juice with Attitude
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Trailer Jack Allowing for Truck Tailgate Clearance for Homesteader Trailer
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Q&A: Edge Juice with Attitude Programmer that Fits 2018 Ram 4500
- Q&A: Is Trimming Required to Install Westin HDX Grille Guard on a 2010 Dodge Ram 2500
- Q&A: Replacement Hardware Kit For a Westin HDX Grille Guard On a 2017 Ram 2500
- Q&A: Compatibility of Front Mounted Hitch and Brush Guard on 2018 Ram 3500
- Q&A: Westin HDX Install Picture for 2013 Ram 2500