Specific Measurements of Lead Jack Leg from Lippert Landing Gear Set # LC333964
Question:
What is the length from the center of the drive pin to the bottom of the first stop at the top of the jack? Also my lead jack is 30 3/4inch long with the 2 1/2 inch shaft. If this extra length is at the bottom of the jack shaft, the Lippert 29 1/2inch by 2 1/2inch LC333964 jack will probably work.?????? From the top of my jack to the center line of the drive pin is about 1 3/4 inch , From the drive pin center line , to the bottom of the first bracket stop is 7, There is 15 1/2inch between stops. From the top of the lower stop to the base of the jack is about 6 1/2. What is the length from the top of the lower stop on the Lippert LC333964 to the bottom of the jack leg?
asked by: Jess H
Helpful Expert Reply:
On the lead leg for Lippert Landing Gear # LC333964 the distance from the center of the drive pin to the bottom of the first stop was 7 inches.
From the top of the jack to the center of the pin was 1 inch.
And from the top of the lower stop to the base of the outer tube was 6 inches.
Product Page this Question was Asked From
Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- Landing Gear
- 37 Inch Lift
- Weld-On
- 2 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Where to Measure To Determine if Lippert Landing Gear Jack part # LG-1 Fits Trailer
- Q&A: Dimensions of Lippert Landing Gear LC333966
- Shop: Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
- Shop: Fifth Wheel Hitch
- Q&A: How to Measure to Pick Out Replacement Landing Gear for a Trailer
- Q&A: Determining The Correct Replacement Landing Gear For A 2005 Thor Tahoe Transport 5th Wheel
- Q&A: Replacement Landing Gear Legs for Venture 900 Landing Gear
- Q&A: Replacement Gears for Landing Gear Legs On Thor Tahoe Widelite 5th Wheel
- Q&A: Replacement Parts or Assembly for Landing Gear of 1998 Gulfstream Innsbrook
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: Trailer Wiring Diagrams
- Article: Gooseneck to 5th Wheel Adapters
- Article: 5th Wheel to Gooseneck Adapters
Brad M.
4/29/2020
do you have a measurement from the top of the lead jack tp the top of the motor assembly?A complete diagram would be helpful. My access opening is 23. My existing length of the tube is 27.5 Atwood landing gearThank you!