Recommendation For Rotating Boat Mirror That Clamps On To 1-1/4 Inch Square Tube
Question:
Does this mirror clamp fit up to 1 1/4 in square tubes and if mounted vertically will the mirror rotate? Also what is the part # for this in black? My plan is to mount it on the Bimini top support that is 1 1/4 inch square tubing adjacent to the drivers helm of the boat. Thank you.
asked by: Don W
Expert Reply:
The CIPA Concept II Rearview Boat Mirror, Item # CM11071, will clamp to square or round frames. It is designed to fit windshield frames but should work with the Bimini top support. It fits frames from 3/8 inches to 1-1/4 inches and can also be permanently mounted. I contacted the manufacturer and mounting vertically will not be an issue other than you may have some limited rotation since the rotation component is designed for a horizontal mounting. This mirror only comes in white.
Product Page this Question was Asked From
CIPA Concept II Rearview Boat Mirror - Convex Glass - Windshield Mount - 8" x 4" - White
- Boat Mirrors
- Boat Mirrors
- Convex Mirror
- Clamp-On
- 8L x 4W Inch
- White
- CIPA
more information >
Continue Researching
- Article: What is the Best Trailer or RV Storage Cover
- Q&A: Recommended Boat Rearview Mirror for Frameless Windshield
- Q&A: Is the CIPA Rearview Boat Mirror CIP54FR Suction Cup Mounted
- Q&A: Best Wheel Finish For Salt Water Using ST175/80D13 Boat Trailer Tire
- Q&A: Comparing a 185/80-13 Tire to the 175/80-13 Size on Americana Trailer Tire AM1ST77
- Q&A: Self Centering Keel Roller and Mounting Hardware For Boat Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 2023 Best Gifts for Auto Enthusiasts
- Q&A: Replacement Bearing Buddy Bras for Bearing Buddies with 2 inch Outer Diameter
- Q&A: Selecting Bearing Buddy Grease Cap Covers for 2-Inch Diameter Bearing Buddy