Recommended Solution To Keep Grease Caps Lubricated And To Avoid Caps From Falling Off
Question:
Hello, We used the provided plastic ring to really get the grease cap cover off well but they have fallen off on two of these hubs? Is there a better grease cap we can buy or better yet one with a zerk fitting as these hubs do not allow for maintenance greasing?
asked by: Anthony A
Expert Reply:
You would need 1.98 bearing protectors such as Bearing Buddy Bearing Protectors # BB1980A-SS to fit with the Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 # AKIHUB-440-2-1K . The purpose of this Bearing Buddy is to first protect your bearings by keeping water out and ensuring there is enough grease in the hub
Bearing Buddies are meant to be driven in with a mallet or hammer, not screwed in. As long as the outside diameter of the Bearing Buddy corresponds with the inside diameter of the hub bore (1.98), the Bearing Buddy will fit very tightly and will not pop out. I have linked a complete install video of the Bearing Buddy.
Products Referenced in This Question
Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - L44643 Bearings - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Pre-Greased
- Standard
- L44643
- L44643
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- etrailer
more information >
Bearing Buddy Bearing Protectors - Model 1980A w/ Auto Check - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.98 Inch
- Bearing Buddy
more information >
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1980A-SS w/ Auto Check - Stainless Steel (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.98 Inch
- Bearing Buddy
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Can etrailer 2,000 lb Axle be Flipped
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 7 Common Questions Everyone Has About Trailer Tires