Will Curt Front Trailer Hitch Receiver # C31068 Fit a 2009 Ford F-150 With Smittybilt Bull Bar
Question:
I have a smitybuilt bull bar installed where the tow hooks were ,can I install this hitch and keep the bull-bar. I realize I have to remove the bull-bar to install the hitch.
asked by: Bill
Expert Reply:
On the 2009 Ford F-150 4WD, the Curt Front Mount Trailer Hitch Receiver, part # C31068, will install between the tow hooks and the frame, using the existing M10 bolts that came on the truck. I spoke with my contact at Curt and he could not say that it would fit with the Smittybilt Bull Bar. He did not think that it would work with the Bull Bar.
I am including a link to the installation instructions on the Curt hitch. These instructions will show you where the Curt hitch will attach to the vehicle. It might help you decide if it will work in conjunction with the Bull Bar.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How to Measure Hub Face of Mobile Home Hub and Drum
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Article: How Long Can You Boondock in an RV?
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Slide Topper For 2021 Grand Design Reflection
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Seal With Dimensions to Replace 171255UC
- Q&A: Can Redline 2-Way Pop-Up Roof Vent # 9106-2756 be Used in Rain
- Q&A: Recommended Generator Set for 2019 Forest River Salem 30KQBSS Travel Trailer
- Q&A: Power Output for Dual Fuel Inverter Generators w/ Parallel Kit Gas vs Propane Operation
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)