bing tracking image
Q & A Icon

How to Pick Out Replacement Landing Gear for 2010 Jayco Designer  

Question:

Hello, I am looking for landing gear for my 2010 Jayco Designer. Passenger side. ..I dont see a part number on it... Would you have a leg replacement or can you give me some advice on what to do.? Thanks

0

Expert Reply:

In order to pick out a direct replacement for the landing gear on your trailer we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Reese Tandem Landing Gear Set # RP500708. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the Reese Kit .

I attached a picture that shows the dimensions that this landing gear set would fit with.

The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.

If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.

The installs are pretty basic as long as the weld mounts match up like we talked about. If they don't you'd need to find someone to weld the legs on.

expert reply by:
0
Jameson C
click to enlarge

Products Referenced in This Question



Video/Article/FAQ this Question was Asked From

Article or Video