Will Curt RV Bumper 2 Trailer Hitch Receiver Fit a Slightly Larger than 4 Inch Bumper
Question:
Does this unit fit over a 4x 4inch bumper with the aluminum flashing on it? I ask because my camper has the flashing glued on and it increases the width and height. Thanks
asked by: Dustin
1
Helpful Expert Reply:
Curt RV Bumper 2" Trailer Hitch Receiver # E-100 is designed for 4 inch square, steel bumpers so to use it you would likely have to remove an area of that aluminum. The hitch needs to be right up against the steel bumper anyway; any of the similar hitches would be the same way.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Curt RV Bumper 2" Trailer Hitch Receiver
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Carry Bikes While Towing a Travel Trailer
- Q&A: Can a Trailer Hitch be Installed on the Back of a Trailer
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Recommended Weight Distribution System for a Minivan Pulling a Pop Up Camper
- Q&A: Recommended Slide Out Topper For A 138-1/2" Flange To Flange Measurement
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Q&A: How Much Does the Kuat Transfer V2 Weigh?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Best Bike Racks for Electric Bikes
- Q&A: Will 8 Lug Spare Tire Fit on Curt Trailer Hitch Mounted Spare Tire Carrier
- Q&A: What is the Difference Between a Class II and a Class III Hitch?