Troubleshooting Clicking When Raising Trailer Electric Landing Gear
Question:
My jacks work fine until it gets weight on it then starts clicking and quits raising the camper
asked by: Kenny S
0
Expert Reply:
Clicking typically is caused by insufficient amperage for the jack motor to allow them to raise and lower. Make sure your battery is fully charged and the ground wire is securely attached from the motor to the trailer battery. That fixes the problem most of the time.
Other possibilities is you'd need a new motor or gear box. Which I'd need to see what your camper has now to see if we have a replacement solution.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 5,500 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- Landing Gear
- 35 Inch Lift
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Landing Gear for 2002 Carriage Cameo F34CK3 5th Wheel Trailer
- Q&A: Replacement Landing Gear for a Keystone Laredo 5th Wheel Trailer
- Q&A: Troubleshooting Landing Gear on Fuzion Toy Hauler That Will No Longer Lift Trailer
- Q&A: Replacement Powered Landing Gear Setup for 2007 Keystone Laredo LA25RK07
- Q&A: Complete AC System With An Advent 13.5K BTU Low Profile AC Unit
- Q&A: Replacement Follow Landing Gear Leg for 1998 Fleetwood Savanna 5th Wheel
- Q&A: How To Determine What Replacement Landing Gear Is Needed For A 2010 Keystone Outback 285FL
- Article: Trailer Wiring Diagrams
- Article: Performance Chips and Modules
- Article: Stability Control for Heavy Duty Vehicles
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: What is Boondocking
- Article: Rooftop Cargo Carriers
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps