Manual Scissor Jack to Replace Electric Jacks on Springdale Summerland Series SM2450 by Keystone
Question:
Can I cut the wires coming from the trailer and cap and tape each one separately? Or will I have to disconnect the wiring from the battery?
asked by: William M
Helpful Expert Reply:
We have scissor jacks like the Ultra Fab Jacks part # UF48-979002 that have 24 inches of lift and a 6,500 lb capacity.
When you remove your old jacks and wiring basically you'll just have to start by removing the wiring near the jacks and switch and work your way back to where it connects to your RV's power source and then take it all out. Or if you want to leave the wiring in place you can disconnect it from the battery and then remove only what's easily accessible.
Product Page this Question was Asked From
Ultra-Fab Ultra Scissor Jacks - 24" Lift - 13,000 lbs - Qty 2
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Scissor Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Can A Bent Leg For The Lippert High-Speed Power Stabilizer Jack Be Replaced?
- Q&A: Solution for Bent Leg on Lippert Powered Electric Stabilizers
- Q&A: Weight Capacity of the Lippert Components High-Speed Power Stabilizer Jacks
- Q&A: Mounting Tab and Hole Size and Spacing of Ultra-Fab # UF48-979006 Scissor Jack
- Article: Trailer Wiring Diagrams
- Q&A: Scissor Jack Recommendation for 31 ft Premier Travel Trailer
- Q&A: Rear Receiver Hitch For My 5th Wheel Toyhauler To Double Tow
- Q&A: Dexter P-15 SLR Axle SN D4484069 Weight Capacity and Replacement Axle
- Article: How to Install an RV Awning From Scratch
- Article: Best Bike Racks for Electric Bikes
- Article: Best Ladder Racks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Which Sway Control Hitch is Right For Your Trailer?
William O.
2/20/2018
Can I cut the wires coming from the trailer and cap and tape each one separately? Or will I have to disconnect the wiring from the battery?