Troubleshooting Prodigy Brake Controller that Stopped Working with Brake Application
Question:
My controller has worked flawlessly for the last 8years. Now it wont work with the brake pedal, but works with the Manuel lever. The code on the controller is - - What does this mean?
asked by: Duane Z
0
Expert Reply:
Can you verify that the red wire of the controller is getting voltage when the brakes are applied? Sounds like the issue is that the controller just isn't getting the brake signal and not knowing when to activate.
If you have a 2000's era GM vehicle check the third brake light fuse. When that blows (and it blows easily on GM vehicles), you'll see brake controller stop working like you described.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Parts Needed to Install 7-Way/4-Way on 2024 Kia Telluride with LED Taillights
- Q&A: How do I Tell if the Brake Controller is Bad
- Q&A: How Is Spring Bar Tension Set Up with Trailer Weight Distribution System