Recommended Wiring Connectors To Avoid Soldering with Replacement Switch for Husky Brute Jack
Question:
how do you chg the switch with out sautering the wires back on i already purchased the switch from e trailor i just need to know how to change the switch with the new one
asked by: Roy A
0
Expert Reply:
If you don't wish to solder the wires onto your replacement switch, you can use the Female Spade Terminal Quick-Disconnects like # DW01899-1 to give you quick connections you can crimp onto the wires.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Female Spade Terminal Quick-Disconnect - 16-14 Gauge - Fully-Insulated PVC - Qty 1
- Wiring
- Wire Connectors
- Quick Disconnects
- 16-14 Gauge
- Deka
more information >
Continue Researching
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: Modern Tire Size Equivalent for Replacing F78-15ST
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What Battery Comes with Bright Way Push-to-Test Trailer Breakaway Kit # 3802311
- Q&A: Where Can I Purchase Replacement Spade Terminals
- Q&A: Availability of Replacement Bullet Connectors for Trailer Lighting
- Q&A: Does Power Wire of Curt Trailer Wiring for 2022 Ford Maverick Have to Run to Vehicle Battery
- Q&A: Can You Hook Power Wire Up From Curt Harness to In-Bed 12 Volt on 2022 Ford Maverick
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Replacement Automotive Lighting