Diameter of the Replacement Handle Shaft Part # TJD-12000-SHABUS
Question:
What is the outside diameter of the shaft and the interior diameter of the bushing?
asked by: Ron
1
Helpful Expert Reply:
I went out to our warehouse and measured the Replacement Handle Shaft part # TJD-12000-SHABUS for you. The outer diameter of the shaft is exactly 1.00" and the inner diameter of the bushing is just slightly larger measuring exactly 1.02".
I have attached a few photos with the above dimensions shown for you as well.
expert reply by:
Conner L
1
click to enlarge
click to enlarge
Product Page this Question was Asked From
Replacement Handle Shaft for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Handle Rod
- etrailer
more information >
Continue Researching
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Q&A: Replacement Parts for the Square Direct Weld Jacks
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Parts for Bulldog Square Jack
- Q&A: Repair Kit for Ram Series 12000 Trailer Jack
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Q&A: Replacement Parts For Ram 12K Support Capacity Jack # TJD-12000SP-F2
- Q&A: Replacement Brass Bushing and Rod for 12,000 lb Fulton Jack
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch