Are Grease Fittings Threaded In or Pressed In on Wet Bolt 126B2
Question:
are the zerks threaded or pressed in? I find the pressed in ones come out when grease gun is removed.
asked by: Curt
0
Expert Reply:
The grease fitting on wet bolt # 126B2 is pressed in. I actually tried to pull one out using pliers but it would not budge so I don't think you are going to have any issues with these coming out!
expert reply by:
Michael H
0
Product Page this Question was Asked From
Wet Equalizer Bolt with Locknut and Grease Zerk for Double-Eye Springs - 3" Long
- Trailer Leaf Spring Suspension
- Suspension Bolts
- Camper
- Car Hauler
- Utility Trailer
- 9/16 Inch Diameter
- 2-5/16 Inch Long
- Redline
more information >
Continue Researching
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Can Tandem Axle Trailer Suspension Kit APT8 be Ordered with Wet Bolts
- Article: How to Raise Your Travel Trailer Height
- Q&A: Issue with Bearing Buddy Leaking Grease from Overfill Port
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Axle Components For Dexter D80 8,000LB Axle Under 2016 Landmark Orlando 5TH Wheel
- Article: Most Popular Wheel Bearings
- Q&A: Difference Between Single, Dual and Free Backing Servo Brake Assemblies
- Q&A: Can I Use Heavier Rated Leaf Springs on Trailer Without Causing Damage
- Q&A: Wet Suspension Bolt vs a Regular Suspension Bolt
- Q&A: Torque Rating Requirements for Installing Leaf Springs on a 7000 lb Tandem Axle Trailer