Where Does Metal Plate for Installing Jensen Antenna # AN519 Install
Question:
Performing a top-mounted installation on an ultralight travel trailer. Does the metal plate install between the plastic antenna base and the roof, or does the metal plant install inside the travel trailer with the bolts passing through through the roof?
asked by: Jesse
1
Helpful Expert Reply:
When installing the Jensen Antenna # AN519 the metal plate would go on the inside of the roof so that when you torque down the install hardware the force gets spread out enough that the hardware doesn't pull through the roof.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Jensen Antenna - Rooftop or Side Mount
- RV Antennas
- AM/FM Antenna
- 180 Inch Cable
- Rooftop Mount
- Side Mount
- Jensen
more information >
Continue Researching
- Shop: RV Antenna and Radio
- Shop: Jensen Antenna - Rooftop or Side Mount
- Video: Jensen RV Antennas - AM/FM Antenna - AN519 Review
- Q&A: Recommended Replacement For An Atwood GC6AA-10E Water Heater
- Q&A: Can I Patch My RV Roof Top Membrane Instead Of Replacing It
- Q&A: How to Determine Enclosed Trailer Roof Weight Capacity
- Q&A: How to Choose Correct Fastway ONEstep Wheel Chocks
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Trailer Wiring Diagrams
- Q&A: Wiring Guide for Optronics Stop, Tail, Turn Light RVSTB60
- Q&A: Do I Have To Reseal My Roof When Using the MaxxAir In Place Of a Fan-Tastic Vent Roof Vent
- Q&A: Can the Jensen Antenna AN519 Be Used On a Boat
- Article: What is Boondocking
- Article: Calculating Portable Generator Power Needs
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Repair an RV Roof