Will SumoSprings Part # SSR-307-47 Interfere with Factory Air Suspension on a 2018 Ram Rebel 1500
Question:
Will these fit my 2018 ram rebel 1500 with air suspension?
asked by: Bill
0
Expert Reply:
The SumoSprings Solo Custom Helper Springs part # SSR-307-47 will physically ft onto your 2018 Ram 1500 Rebel however, the factory air suspension system will likely interfere with the jounce springs. SuperSprings states that when they tested the SumoSprings on a model with air suspension, the air suspension system had problems while trying to lower the truck.
Unfortunately, all of the other suspension enhancements we have for your vehicle will run into the same issue listed above.
expert reply by:
Conner L
0
Product Page this Question was Asked From
SumoSprings Solo Custom Helper Springs - Rear Axle
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Jounce-Style Springs
- Light Duty
- SuperSprings Intl
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Difference between Timbrens and SumoSprings for My 2022 Ram 1500 4x4?
- Q&A: Recommended SumoSprings for a 2021 Ram 1500 Pulling a Travel Trailer
- Q&A: How To Prevent Sag While Towing With a 2020 Ran 1500
- Q&A: Best Suspension Enhancement Option For A 2022 Ram 1500
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Best SumoSprings For 2022 Ram 1500 Towing Camper Trailer
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Best Air Bag Suspension (2023)
- Q&A: Are the Blue or Black SumoSprings Going to Be Best For 2020 Ram 1500?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Which SumoSprings Kit for 2020 Ram Rebel 1500
- Article: Stability Control for Heavy Duty Vehicles
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: How Your RV Water System Works: A Complete Newbie's Guide
Chuck
5/21/2024
When pulling my gooseneck horse trailer I occasionally get an overload light on my air ride ram 1500. Did the somosprings only give problems when lowering for entry? I don’t need to use that.