Pipe Mount Trailer Jack Recommendation to Replace Shelby Jack # 5754A
Question:
Looking to replace Shelby jack assembly to the matching welded on support. The model # reads 5754A and the rest if any is scratched off. 850# capacity. Need the correct O ring to snap in. Thanks
asked by: Rick S
1
Helpful Expert Reply:
We did have a customer come back and say that the Fulton jack part # FTJ120W0301 will attach just fine to the pipe mount on the trailer frame where a Shelby jack just like yours was installed.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Continue Researching
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Article: Trailer Wiring Diagrams
- Q&A: Shelby Model # 5784 Trailer Jack Replacement Option
- Q&A: Jack Recommendation for Replacing Shelby Jack 5784
- Article: Most Popular Wheel Bearings
- Article: Best Boat Trailer Jacks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Shelby Jack Model 5856A Replacement Recommendation on Jet Ski Trailer
- Q&A: Recommended Replacement for a Shelby Trailer Jack Model 5756
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Article: Trailer Lighting Requirements
- Article: Trailer Jacks