Will Slipper Spring Hanger # 115706S Work with a 2 or 3 Slipper Spring
Question:
will this slipper spring hanger work for 2 or 3 leaf spring?
asked by: Tim
0
Expert Reply:
As long as the slipper spring you have has a width of 1-3/4 inches and the spring eye diameter is 9/16 of an inch this Rear Hanger for Slipper Spring # 115706S would work well for you.
I attached an FAQ article on slipper spring trailer suspension for you to check out also.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Rear Hanger for 1-3/4" Slipper Spring
- Trailer Suspension Parts
- Hangers
- Camper
- Car Hauler
- Utility Trailer
- Slipper Springs - 1-3/4 Inch
- 9/16 Inch Diameter
- Single Axle
- Tandem Axle
- Triple Axle
- Redline
more information >
Continue Researching
- Q&A: Can Trailer Tire Size 175/80-13 Replace Size 185/80R13
- Q&A: Options For Replacing A Tie Down Turbo Lube 48394 Clear Oil Bath Cap
- Q&A: Bearings For Older Trailer Hub 22834
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Installation of Coupler Repair Kit # CP02-050
- Q&A: Latch Repair Kit For Bulldog A256 2-5/16" Ball Latch Coupler
- Q&A: What Is The Cup Holder Width of the Optronics Foldable Cup Holder
- Q&A: Can 8 inch Trailer Wheel be Replaced with 12 inch Wheel and Tire
- Article: How to Raise Your Travel Trailer Height
- Article: Where to Position the Trailer Axle?
- Article: Determining Trailer Tongue Weight
- Article: How Does a Trailer Hitch Coupler Work?
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Tell the Weight Rating of a Trailer Axle