Will the Redline 1/2 Inch Hinge Pin Nipple Work with the 1/2 Inch Diameter Hinge Pin
Question:
I surmise your 1/2inch i.d hinge pin Nipples HPN214 will work with the 1/2inch dia hinge Pin HP412? It would seem too tight though. Or is clearance factored into the specs. What if I needed to implement a hardware store unthreaded portion bolt into your 1/2inch hinge nipple. Would a 1/2 be too tight of would I need like a 7/16 or 15/32 bolt?
asked by: Dave S
Expert Reply:
The 1/2 Inch Diameter Hinge Pin Nipple # HPN214 referenced in your question will work perfectly with the 1/2 Inch Diameter Hinge Pin # HP412. I actually went out to our warehouse to test the two items together and the fit is not too tight at all.
We have measured the inner diameter of the hinge pin nipple with a digital caliper in the past and found a true diameter of right at 0.52 inches, making it compatible with a 1/2 inch hinge pin.
Products Referenced in This Question
1/2" Diameter Hinge Pin, 4-1/2" Long
- Trailer Door Hinges
- Hinge Pin
- Build Your Own Hinge
- 4-1/2 Inch Long
- 1/2 Inch Diameter
- Redline
more information >
Product Page this Question was Asked From
1/2" Diameter Hinge Pin Nipple, 2-1/4" Long
- Trailer Door Hinges
- Hinge Pin Nipple
- Build Your Own Hinge
- 2-1/4 Inch Long
- 1/2 Inch Diameter
- Weld-On
- Redline
more information >
Continue Researching
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Q&A: How to Correctly Position Oil/Grease Seal in Trailer Hub
- Q&A: Installation of Ramp Door Hinge Polar 1902
- Q&A: Dimensions and Lift Capacity of Ramp Spring # RS16933LH
- Q&A: Maximum Throw/Pin Extension for Spring Latch
- Q&A: Removing Rusted Hinge Pin on Trailer
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Article: Trailer Lighting Requirements