Maximum Inlet Pressure for Valterra Water Regulator # A01-1120VP
Question:
is there a MAX pressure this can handle?
asked by: Derek
0
Expert Reply:
I spoke with my contact at Valterra regarding the Water Regulator # A01-1120VP referenced in your question. She stated that the maximum inlet pressure for this regulator is 150 psi.
I have attached a short video demonstration on this product that you can also check out.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Valterra RV Water Pressure Regulator - 40 to 50 psi - Brass
- RV Water Pressure Regulator
- Water Pressure Regulator
- Screened Washer
- Brass
- Valterra
more information >
Continue Researching
- Q&A: Can a Pop Up Camper with 8 Inch Tires be Upgraded to 10 Inch Tires
- Q&A: What Is the Internal Clearance of the 30A SurgeMinder Surge Protector?
- Q&A: Selecting The Correct Replacement Venture Landing Gear Follow Leg On a 2005 Thor Tahoe Transport
- Q&A: Wiring Diagram of Atwood Water Heater Relay 93849
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Replacement Electric Drum Brake Assembly to Replace Dexter 023-327-00
- Q&A: Thread and Fuel Line Size Dimension for the DeeZee Connector Kit # DZ97960
- Article: Trailer Wiring Diagrams
- Q&A: How Do You Know If You Need A Water Regulator Going To Your Motorhome or Trailer?
- Article: Determining Trailer Tongue Weight
- Article: Gooseneck to 5th Wheel Adapters
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller Installation: Starting from Scratch