Mounting Hole Dimensions Of Carr Hoop Step # CARR103991
Question:
question about carr103991. I need the distance between bolt holes onleft side to right side.
asked by: Joellekarelli
0
Expert Reply:
The Carr Custom-Fit Side Steps - Hoop II - Black Powder Coated Aluminum - 7" Step - 1 Pair # CARR103991 have a measurement of 1.9 inches vertically and 8.5 inches horizontally measuring hole center on center. I've attached a photo to assist.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Carr Custom-Fit Side Steps - Hoop II - Black Powder Coated Aluminum - 7" Step - 1 Pair
- Nerf Bars - Running Boards
- Hoop Steps
- 3-1/2 Inch Wide
- Matte Finish
- Fixed Step
- Aluminum
- Black
- Carr
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is Carr Step CARR103991 One Step or Two Steps
- Q&A: What Are The Dimensions Of The Carr Custom-Fit Side Step Mounting Brackets?
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: Troubleshooting a BrakeRite SD Electric-Hydraulic Actuator Not Working After Replacing Brake Pads
- Q&A: Replacement Trailer Clearance Lights for GloBrite 122r/122y
- Q&A: Where Do the Carr Custom-Fit Side Steps Install on the Vehicle?
- Q&A: Troubleshooting Dim LED Trailer Lights after New Wiring and Light Assembly Installation
- Q&A: Possible Causes for Dim Trailer Lights
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller Installation: Starting from Scratch
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Pintle-Hitches