Wiring Third Brake Lamp and Dome Light in Camper Shell on 2005 Chevy Silverado.
Question:
How do I wire-up the brake and inside dome light from canopy to 2005 Silverado extended cab Z71
asked by: Larry
Expert Reply:
The main trailer wiring harness is located under the truck bed, usually above the spare tire. There is usually a socket for your trailer connector to plug into, but if you peel back the wire loom you will find a light blue wire further up in the wiring harness that is intended for use for a third brake lamp on a camper shell.
The dome lamp should be wired into a 12 volt power source and should have a toggle switch installed on the circuit. Probably the easiest method would be to use the running light circuit, so that the dome light will only work while the headlights are on, but you will need to install a switch.
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Recommended Flat Towing Setup for a 2016 Jeep Wrangler Using a ReadyBrute Elite II Tow Bar
- Q&A: Replacement for Pollak PA66-MD40 Connector
- Article: Flat Towing Package for 2011 Chevrolet HHR
- Q&A: Blule Ox Baseplate For A Diesel 2020 GMC Sierra 3500 Denali
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Q&A: How To Mount Pollak Connector PA66GF30
- Q&A: Parts Needed to Flat Tow 2023 Ford Bronco