Diameter of Curt Round, Snap-Ring Swivel Jack Crank Tube
Question:
This for a top crank model jack2000#. Can you tell me what size the shaft is where the crank handle attaches to is?
asked by: James
0
Expert Reply:
The diameter of the topwind handle on the Curt Jack part # C28304 is 1/2 inch. This is the round metal section that attaches to the crank of the jack and the red knob.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Round, Snap-Ring Swivel Jack - Weld On - Topwind - 15" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Swivel Jack
- Topwind Jack
- 15 Inch Lift
- Weld-On
- With Rectangle Foot
- CURT
more information >
Continue Researching
- Article: What is Overlanding? How to Start your Overlanding Journey
- Q&A: Does B&W Companion OEM 5th Wheel Trailer Hitch BWRVK3370 Come Assembled
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Q&A: Does HBA-CAM Adapter Module for Hydrastar Electric Over Hydraulic Brake Actuators have 2 or 4 Wires
- Q&A: Replacement For Fulton Drop-Leg Stabilizer Jack
- Q&A: Will Swagman Bike Rack Fit Spare Tire with Hard Plastic Cover
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?
- Q&A: Selection of Special Trailer Tires for 5th Wheel Trailer to Avoid Blowouts
- Article: RV Cell Boosters, How Do They Work?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight