How Far Out Does the Erickson Arched Loading Ramp Set Extend
Question:
I just purchased a snow blower, which I will keep in my garage until the season ends, at which time I plan to store the snow blower in my basement. To get the snow blower in my basement I need a ramp, due to the fact there are 4 - 8 steps going down from the garage into the basement. Will the EM07464-2 work?
asked by: John B
Expert Reply:
As long as the distance from the first step to the ground is not more than 80" long and your snow blower does not weigh more than 1,600 lbs (unlikely) then the Erickson Arched Loading Ramp Set part # EM07464-2 may work for you. When measuring your steps you will need to measure across the steps not straight out.
I have attached a review video of these ramps for you as well.
Product Page this Question was Asked From
Erickson Arched Loading Ramp Set - Center Fold - Steel - 80" Long x 11" Wide - 1,600 lbs
- ATV Ramps
- Ramp Set
- Center-Fold
- 11 Inch Wide
- 1600 lbs
- Arched
- 80 Inch Long
- Steel
- Erickson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Longest Set of Folding Ramps for Loading Generator in Truck Bed
- Q&A: Replacement Converter for Magnetek 7345
- Q&A: Height Measurements of Erickson Beg Bed Load Extender
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Maintenance Schedule
- Q&A: How To Determine Where Leaf Spring Hangers Should Be Placed
- Q&A: Fresh Water Pump to Replace Shurflo 2088-422-144
- Q&A: Safety of Using Hitch Extender and Other Options To Clear Spare Tire on Jeep Liberty
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Would Stallion Arched Ramps Loading Ramp Set Be Good For Loading Snowblower Into Truck Bed
- Article: Stability Control for Heavy Duty Vehicles